QUALITY IMPROVEMENT ON PIPE DEFECTS AT WELDING ERECTION PROCESS

Authors

  • Fairul Anwar A.B. Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • N. E. S. A. Aziz Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • M. H. M. Tajudin Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • N. F. Ghazali Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • M. F. Halimi Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • R. G. J. Ren Universiti Kuala Lumpur, Johor Bahru, Malaysia.
  • S. A. A. Nazri Universiti Kuala Lumpur, Johor Bahru, Malaysia.

DOI:

https://doi.org/10.70672/1xzp6026

Keywords:

Lean Six Sigma; Improvement; P; (List ipe Defects; Welding Erection Process; DMAIC.

Abstract

The project was carried out at Aldats (Malaysia) Sdn. Bhd., located in Bandar Baru Seri Alam, Masai Johor. Aldats (Malaysia) Sdn. Bhd. offered three main services which are Engineering and Construction, Manpower Supply and Trading. Current pipe defect at engineering and construction services is 40% which in September 2022. The aim of this project is to reduce pipe defect at welding erection process by at least 20%. After the quality improvement by implement DMAIC, the result shows a decreasing to 27% in December 2022.

Downloads

Published

12-07-2024

Issue

Vol. 8 No. 3 (2024)

Section

Articles

License

Copyright (c) 2024 Malaysian Journal of Industrial Technology

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Journal of Engineering Technology (JET)  is an open-access journal that follows the Creative Commons Attribution-Non-commercial 4.0 International License (CC BY-NC 4.0)

How to Cite

Fairul Anwar A.B., N. E. S. A. Aziz, M. H. M. Tajudin, N. F. Ghazali, M. F. Halimi, R. G. J. Ren, & S. A. A. Nazri. (2024). QUALITY IMPROVEMENT ON PIPE DEFECTS AT WELDING ERECTION PROCESS. Malaysian Journal of Industrial Technology , 8(3), 106-114. https://doi.org/10.70672/1xzp6026