Transient Stability Analysis: Evaluation of IEEE 9 Bus System Under Line Fault Conditions

Authors

  • M. J. Tahir Section of Electrical Technology, Universiti Kuala Lumpur British Malaysian Institute
  • I. A. Latiff Section of Electrical Technology, Universiti Kuala Lumpur British Malaysian Institute
  • M. Alam Institute of Business and Management (IoBM), Korangi Creek, 74900 Karachi, Pakistan
  • M. S. Mazliham Universiti Kuala Lumpur, Malaysia France Institute(MFI)

Keywords:

IEEE 9 bus test system, Power Flow Analysis, Transient Analysis, line fault, ETAP

Abstract

Switching is the most common practice in a grid network, which is done usually to shift the load or isolate the faulty part from the network. As the result network destabilizes when these kind of switching operation occurs. To stabilize the grid network, switching of appliances is required to adjust accordingly and network equipment needed to be analyzed for the improvement of grid network design. In this paper, the effect of the switching operation under fault line condition in a grid network 13.8kV/16.5kV/18kV/220kV is being analyzed, to evaluate the system stability in terms of branch power, generator current, system voltage and frequency. ETAP software is used to express the transient and power flow response of the presented grid network.

Downloads

Published

01-11-2017

Issue

Vol. 5 No. 1 (2017)

Section

Articles

License

Journal of Engineering Technology (JET)  is an open-access journal that follows the Creative Commons Attribution-Non-commercial 4.0 International License (CC BY-NC 4.0)

How to Cite

M. J. Tahir, I. A. Latiff, M. Alam, & M. S. Mazliham. (2017). Transient Stability Analysis: Evaluation of IEEE 9 Bus System Under Line Fault Conditions. Journal of Engineering Technology, 5(1), 54-58. https://ejournal.unikl.edu.my/index.php/jet/article/view/272