DESIGN AND FABRICATION OF MULTIPURPOSE STATIONERY RACK

Authors

  • N. Manap School of Mechanical Engineering, College of Engineering, Universiti Teknologi MARA, Cawangan Terengganu, Kampus Bukit Besi, 23200 Bukit Besi, Dungun, Terengganu, Malaysia.
  • TAA.T Sulaiman School of Mechanical Engineering, College of Engineering, Universiti Teknologi MARA, Cawangan Terengganu, Kampus Bukit Besi, 23200 Bukit Besi, Dungun, Terengganu, Malaysia.
  • N Abd Rahman School of Mechanical Engineering, College of Engineering, Universiti Teknologi MARA, Cawangan Terengganu, Kampus Bukit Besi, 23200 Bukit Besi, Dungun, Terengganu, Malaysia.
  • NA Abd Rahman School of Mechanical Engineering, College of Engineering, Universiti Teknologi MARA, Cawangan Terengganu, Kampus Bukit Besi, 23200 Bukit Besi, Dungun, Terengganu, Malaysia.
  • H Ghazali School of Mechanical Engineering, College of Engineering, Universiti Teknologi MARA, Cawangan Terengganu, Kampus Bukit Besi, 23200 Bukit Besi, Dungun, Terengganu, Malaysia.

Keywords:

stationery rack,3D printer, design

Abstract

The perception of product creation is thriving daily in the realm of modern technology to users. Products with several features have notably altered the modern world. This project shows the construction of a multipurpose stationery rack by gathering knowledge from college students. The prime objective of product development is to expand its market share considering all the college students’ requirement. It is necessary f or a product not only to fulfil college students need but also to cope up with target market specification. Various product development tools have been used to implement the desired concepts. 3D printer machine used to complete the fabrication of this project. The design is done by using SOLIDWORK.

Downloads

Published

01-06-2024

Issue

Vol. 15 No. 1 (2024)

Section

Articles

License

Journal of Engineering Technology (JET)  is an open-access journal that follows the Creative Commons Attribution-Non-commercial 4.0 International License (CC BY-NC 4.0)

How to Cite

N. Manap, TAA.T Sulaiman, N Abd Rahman, NA Abd Rahman, & H Ghazali. (2024). DESIGN AND FABRICATION OF MULTIPURPOSE STATIONERY RACK. Marine Frontier, 15(1), 1-10. https://ejournal.unikl.edu.my/index.php/mf/article/view/481